Description
EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT
Solvent-based, full-bodied black bitumen paint for metal protection
EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT is a solvent-based, full-bodied black bituminous paint. When dry, the product forms an odourless and taint-free black film suitable for metal protection as well as overcoating wood and felt.
Usage
EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT provides an effective waterproof, weatherproof, corrosion-resistant protective coating. It is resistant to low concentrations of alkalis and acids and can withstand prolonged oxidation. It is suitable for application to a wide variety of materials including iron, steel, lead, zinc, aluminium, asbestos-cement, concrete, stone, wood, felt and brick and is mainly used for:
- Metal protection - corrugated iron sheets, fire escapes, stairways, ladders, storage tanks, gutters, downpipes, fences, railings, gates etc.
- As a protective coating for concrete structures, stone, brick, concrete screeds and sand/cement surfaces.
- Overcoating felt/wood.
Advantages
- Fast drying.
- For use on most common building surfaces.
Type of Solvent White spirit Flashpoint ca. 40°C Film Thickness Per Coat @ 11m2 / Ltr Wet – 0.1mm Dry – 0.05mm Chemical And Water Resistance Resistant to: most salt solutions, dilute acids and alkalis, water and alcohol. Not resistant to: oils, solvents and some detergent solutions Service Temps-20°C to +50°C.
Packaging
2.5L , 5L
Colour
Black
Product Details
|
Chemical Base |
Shelf Life |
Density |
Viscosity |
| Solvent-based bitumen | 24 months from date of manufacture in tightly sealed, undamaged containers. | ca. 0.9 g/cm3 at 20°C | 700-1200 cP |
Storage Conditions
EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT contains a flammable solvent, and all normal precautions against fire must be taken during both storage and use. Store in original container in cool (5°C - 25°C) dry conditions. Keep away from sources of ignition.
Technical Information
Service Temperature
-20°C to +50°C
Ambient Air Temperature
Drying time
4-6 hours depending on drying conditions
Application Steps
Substrate Preparation
As with all surface coatings, preparation of the surface is of great importance and will influence the degree of adhesion obtained and the life of the coating. All surfaces must be sound, stable and thoroughly clean and dry. Metal surfaces should be wire-brushed to remove rust. Where long-term protection is required an initial treatment of a rust-inhibitive product such as red lead or zinc phosphate should be used. Loose or blistered paint should be removed, as should tar-based paint systems. New galvanised surfaces should be roughened with a wire brush or treated with a proprietary etch primer. Porous surfaces should be primed with Black Jack® Bitumen & Flashing Primer.
APPLICATION
EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT is ready for use and should not be thinned. Stir thoroughly before use. Apply by brush or spray.
A minimum of two coats of EVERBUILD® BLACK JACK® 901 BLACK BITUMEN PAINT should be applied. The first coat should be allowed to dry (normally 2-4 hours depending on weather conditions) before the second coat is applied.
Protective Coating On Concrete, etc:
since concrete and some stone surfaces may be porous, an initial primer coat of EVERBUILD® BITUMEN PRIMER should be applied.
CLEANING OF TOOLS
Tools may be cleaned by using white spirit. Any spillage should be wiped off surfaces before the bitumen paint has set
Downloads